1988 Johnson 15 Hp Manual
Re: 1988 15HP Johnson. That knob adjusts the idle mixture. Pump fuel bulb till hard, set throttle to the start position, pull the choke out and pull it over. Maintaining Johnson/Evinrude 9.9 & 15 hp 2 cycle outboards. 1974 – 1992 (Information & normal repairs). All 15 hp motors for both Johnson and Evinrude were called 15hp. LH side of a 1980 Johnson showing the manual starter.
1988 Evinrude 15 Hp Repair Manual
MERCURY RELATED SEARCHES: Drive Shaft Bushing, Bearing and Lubrication Sleeve 1. Inspect drive shaft bushing and bearing surface to determine condition of corresponding upper drive shaft bushing and lower drive shaft needle bearing. If drive shaft surface is rusted, pitted, discolored (blued – lack of lubrication) or worn; replace drive shaft and corresponding bushing/bearing.
1988 Johnson 60 Hp Outboard
DO NOT remove bushing or bearing if replacement is not necessary. A - Bushing surface b - Bearing surface c - Upper drive shaft bushing d - Lower drive shaft needle bearing IMPORTANT: If upper drive shaft bushing or lower drive shaft needle bearing appear to be spinning in their respective bores, the gear housing should be replaced. GEAR HOUSING 2. To replace upper drive shaft bushing, use Snap On. Expanding Rod (CG 40-4) Snap On Collet (CG 40A6) Slide Hammer (91-34569A1).